wire pulls
Thursday, January 5th, 2012flush slam latch For the wiring of your Super Rod, you will need some assembly, but it should be no problem with the help of this detailed guide.
Step 1 : To begin, you will wire pulls need to prepare a basic kit with some wiring and a fuse block.
Step 2 : The size of the Alternator will depend on the quantity of the equipped items on your Super Rod as well as their amount of amperage draws.
Step 3 : A particular amount of current is required for each chosen component for fusing accordingly for protection.To maintain serviceability, you will need to place the items in an accessible but hidden location properly and away from sources of heat.
Step 4 : Select the location of the fuse block first.In this case, the fuse panel will be located behind the side panels built, housed in the trunk for easy access but invisible.A fuse panel support bracket is fabricated on an angle to add to accessibility.
Step 5 : The fuse block is attached with the aid of 10/24 stainless steel screws and the wires are ran behind the unit up over the internal wheel house.The wiring will be hidden by the trunk side panels.
Step 6: You can run the main harness through the rocker panel at the qtr panel window opening bottom, by cutting a clearance hole.
Step 7 : Create a good entry location back up at the original front kick panel for the under dash wiring.
Step 8 : Build a protective saddle below the bottom door hinge which also eliminates metal burrs which may rub the wiring when you going at the installation.
Step 9 : Finish off with a trim panel covering the door hinge opening.For protection and to allow the wiring to pass through, on the upper section, incorporate an oval transition flange.
Step 10 : For wiring protection while pulling through the panels, you can use a black corrugated conduit.Just fold back the edge and feed the corrugated conduit to the wire.You can use electrical tape to keep the end of the wires from hanging on an edge.It also doubles as an attachment location for rope or pull wire when pulling the wires through.
Step 11 : Run the wires through the pre-drilled holes and use a pull string to feed the conduit through the rocker and into the vehicle interior with a pull string.
Step 12 : To feed different components, install a main junction block beneath the dash.When it is